Spectral range: UV 250-410nm (nanometers)
Intensity range: Open
Range: 0-999,999 mJ/cm2 and (mJ / square cm)
Use of power: 3.6V lithium battery
Battery life: 10,000 hours under normal operating conditions
Dimensions: 93L * 63W * 13Hmm (mm)
Weight: 150g (grams)
Ambient temperature: 0 to 45 ° C (degrees Celsius)
Withstand temperature: 110 ° C (degrees Celsius) under the conditions of continuous irradiation does not exceed 10s (seconds)
Measurement accuracy: ± 3%
The calibration cycle: To accurately to ensure measurement accuracy and effectiveness of the proposed calibration period of one year.
Warranty period: from date of purchase within one year warranty, except of man-made damage or damage caused by objective factors.
Used to measure the energy value of different light sources within a certain time of irradiation, it is usually about the amount of light performance;
With the continuous improvement of the UV curing requirements, the UV energy meter has become extremely important in the production process of curing quality monitoring instruments, good control and an essential tool to achieve the consistency of the quality of product curing;
Measuring the spectral range 250-410nm (nanometers), the best sensing UV wavelength of 365nm (nanometers);
How to use:
The energy meter at the top of the switch to the open position "ON" position, this time, the display will show the number "0" mj/cm2 (mJ / square cm).
Ready measurement, the back of the energy meter for ultraviolet UV light in order to ensure the validity and accuracy of the measurements, the photosensitive windows have a clear identity.
When the instrument has been recorded by the sensor to the light source after a certain period, UV ultraviolet light energy, then, can be read from the display on the instrument a positive energy value, energy value of the corresponding units are: mj/cm2 (mJ / square centimeters).
Each time, conducting a new measurement, based on need to turn off the instrument, then turn it on again. The display will re-raised to "0" mj/cm2 (mJ / square cm). Then follow the above steps to continue.
Every time you use, set the switch of the instrument adjusted to open the status is "ON" position displayed on the LCD display reading of "0" mj/cm2 (mJ / square cm), if you do not want to get repeat testing the cumulative energy value, before every measurement, its reading to zero.
If your process is special needs, can also be measured repeatedly, every measurement readings, does not require zero processing, then the last displayed in the instrument readings will be the cumulative value of the repeated measurements.
When the measurement is complete, switch to "OFF" position to switch off the instrument, the correct operation to ensure that the battery life of the instrument.
Note:
Please avoid frequent shaking force apparatus or broken equipment;
Each time the measurement is completed, please turn the meter off, and back into the box custody;
Measurements to avoid the front of the instrument LCD in bright light or high heat environment.
Non-professionals, should not open the instrument adjustment or damage, will affect the effectiveness and accuracy of the instrument's detection. |
